CatCam Camera Manual do Utilizador descarregar pdf (Página 3)

Installation Step Two

The camera mounts using a deep double “J” box. Run a line of Cat 5

wire from the camera to the channel injector and connect wires as

shown.

Attach Cat 5 wire to camera following color coding.

note:

When using quad wire connect

wires only to pins 1, 2, 5 and 6.

Leave the resistor in place

at pins 3 and 4.

note:

When using Cat 5 wire

remove the default resistor

that is in pins 3 and 4 of the

camera

prepare the Cat 5 wires by

stripping 1” of outer sheath

and 1/8” of insulation

attach drip cap,

gasket and frame

insert the 6-32 screws into

frame and bottom holes of

gang box

Note: bottom of lip on drip cap

goes inside frame.You may have

to rotate drip cap 180˚

frame

gasket

drip cap

pin 1 2 3 4 5 6 7 8

Default

resistor

Green

pin 1

Red

Black

Yellow

Bl/W Blue Org/W Orange Gr/W Green Br/W Brown

frame

gasket

drip cap

“Hook” camera mount over the gasket and rotate into place.

Apply RTV to seal from weather.

Add top screws.

Aiming the camera

Insert a 1/8” screw driver in the

steering slot below the lens.

Using the screwdriver, bend

the mount to the point camera

in the desired direction. Never

use the camera to bend the

mount. continued on page 6

1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários

CatCam Camera Manual do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras bridge CatCam Camera