CatCam Camera Manual do Utilizador descarregar pdf (Página 2)

The CatCam is a surveillance system that creates a new channel

to add to existing television channels. The new channel carries a

picture from the camera that is placed anywhere in the home. The

CatCam was designed to install effortlessly into existing coax home

wiring or into new construction.

Contents: Channel Injector

Camera

Power Injector

Power Supply

Coax Jumper

The CatCam is comprised of a camera and a channel injector. The

camera is designed to flush mount indoors or outdoors

(under an eaves

and not directly exposed to the elements)

using a deep double gang J box. The

channel injector is weather resistant and designed to mount indoors

or outdoors close to the incoming CATV or antenna feed. The sys-

tem uses the existing coax cable distribution in the house.

The CatCam was designed to work with Cat 5 wiring. Although the

system will function with quad wire, Cat 5 delivers the highest quality

picture. The Cat 5 allows the use of an automatic line length sensor

and picture compensator. Quad wire does not take advantage of

this enhancement.

Model Differences:

The model 9500HHR series is a high headroom design for CATV

and off air antenna feeds only.

The model 9500BID series is a bi-directional design for use with

CATV cable boxes that are interactive or require bi-directional com-

munications with the cable company.

The model 9510PAL is designed to modulate PAL frequencies and

use CATV or off air antenna feeds.

Installation:

First, locate the incoming CATV or antenna feed and install the

channel injector at that location.

Second, install the camera at the desired location and run Cat 5 wire

from the camera to the channel location.

Third, apply power and select an unused channel for the CatCam

picture to appear on all the televisions.

Installation: Step One

Locate the incoming CATV or antenna feed and existing splitter.

(Usually found on the side of the house, in the attic or near the electrical and phone service box)

Remove the lock screw located on the bottom of the channel

injector and slide the cover off. Use the mounting holes as shown to

affix the channel injector to the wall next to the splitter.

Disconnect the incoming CATV or antenna feed from the existing

splitter and attach it to the channel injector as shown.

Now attach the supplied coax jumper back to the existing splitter

and tighten all connections with a 7/16” wrench.

Use mounting

holes on the

bottom plate to

attach channel

injector to the

wall

Incoming CATV or

antenna coax

Out

to TVs

Incoming CATV or

antenna coax

Supplied coax

jumper goes back

to splitter

Out

to TVs

After

Before

Mount the

injector within

4” of the splitter

Mount the

injector within

4” of the splitter

1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários

CatCam Camera Manual do Utilizador Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras bridge CatCam Camera