CatCam Camera Manual do Utilizador descarregar pdf (Página 8)

CatCam v2 User Manual - Page 8 of 11

7. Setting of Recording Interval

The time between the photos can be adjusted in steps of 10 seconds. The maximum

time is about 40 minutes.

Setting the time is done using the On/Off button. While a quick push on the button

switches the camera ON. Holding the button down enables time setup.

The procedure is as follows:

• In the default state the camera is Off

• Hold the button down until the status light blinks.

• Each blinking increases the interval time by 10 seconds.

• When the desired time is reached release the button.

• The settings will be stored and the camera switches into the recording mode.

8. Change Time Stamp

The photos are overlaid with a time stamp. This time can be adjusted.

Procedure:

1. Open notepad or any other text only editor

2. write:

[date]

2011/04/21

20:35:00

this is setting the date to April 21, 2011 and the time to 8pm 35 minutes.

Make sure that each line, also the last line, is finished by pressing the ENTER

key. File size must be 30 Bytes.

3. save as text file with the name tag.txt (lower case).

4. copy this file in the cameras root directory.

5. disconnect camera

6. switch camera ON, the camera will read the file, set the date and erase the

file.

Older cameras require a different format of the file:

Write:

[date] 2009/12/29 16:58:00 this is setting the date to Dec. 29,

2009 and the time to 4pm 58 minutes. Make sure that the last character after the time

is a space !

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

CatCam Camera Manual do Utilizador Página 8