CatCam Camera Manual do Utilizador descarregar pdf (Página 7)

CatCam v2 User Manual - Page 7 of 11

6. Activate Camera

After the battery is charged the camera can be activated. First unplug the camera

from the USB interface and wait until the light of the camera core goes off.

Press shortly on the button next to the USB interface. The status light (marked by a

circle) comes on. If you have difficulties pressing the button you may use a pencil or

something similar in order to extend your reach.

As long as the device is active the status light blinks shortly every few seconds.

Press again on the button to switch the camera off. This may take some time

depending on the record state. The status light will remain on until the camera is shut

down, you do not need to press more than one time on the button.

If you have programmed recording interval time the setting will not get lost by

switching the camera off.

Note: Even if the camera is equipped with a protective enclosure it is not

recommended to use the camera if there is a possibility for rain or any other condition

where the camera is exposed to water.

Note: Even if the camera is equipped with a protective enclosure it is not

recommended to use the camera if there is a possibility for rain or any other

condition where the camera is exposed to water.

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

CatCam Camera Manual do Utilizador Página 7