CatCam Camera Manual do Utilizador descarregar pdf (Página 8)

Video CatCam User Manual - Page 8 of 12

7. Setting of Recording Interval

The available recording time (defined by memory capacity and battery energy) can be spread

over a longer time. The following graphic shows this. If the chopped pieces of the interval are

added together both bars have the same length. Chopping the recording time into smaller

pieces extends the coverage to a longer time.

continuously

Interval

Total recording time

One cycle consists out of a recording phase and a standby phase in which the camera is

switched off as shown in the following graphic. For both phases the time can be set on the

camera.

Record time

Pause time

…..

Setting these times is done using the On/Off button. While a brief push on the button is

switching the camera ON, holding the button down enables time setup.

The procedure is as follows:

 In the default state the camera is Off

 Hold the button pressed until the status light turns on. Keep pressing the button until the

light turns off.

 Release the button, the light will rapidly flash showing that the camera is waiting for input.

 Press now the button to increase the recording time by 1 minute increments.

 When you are done with setting the recording time, press the button until the light turns

off. You will now adjust the pause time also in 1 minute increments similar to the

recording time before.

 When you keep the button pressed to exit the settings will be stored and the camera

switches into the recording mode.

If you want a continuous recording without interrupts use the same procedure as described

before. Do not input a time, immediately finish by keeping the button pressed. It doesn’t matter if

you do this at setting of recording time or pause time. In both cases the result is that the interval

mode is switched Off.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

CatCam Camera Manual do Utilizador Página 8